Stromberg 2 X 2 Linkage Kit Suit Edelbrock Superdual 9244S
(Prior to Dispatch)
Stromberg 2 X 2 Linkage Kit Suit Edelbrock Superdual
A competitively priced 2x2Super carburettor linkagewith Stromberg Superlinklevers. Use with intakemanifolds that put thecarburettors 10-3/8th inchesapart. See above for typicalmanifold applications.
Designed and manufacturedexclusively by Strombergcarburettor, the TwoSteplinkage range combines clean,traditional looks withmaximum leverage. Each kitcomes pre-assembled andinstalls in just two simplesteps, without the need forextended throttle shafts.These kits are not a 'onesize fits all' solution.Different intakes usedifferent carb spacing, so wemodelled every kit in 3D CADand offer different kits forspecific intakes. If you'rein doubt, simply measure yourmanifold spacing - throttleshaft to throttle shaft.
Check out thefollowing features:
- 10-3/8inch carbto carb
- Extendedthrottle shafts not required
- Fits Edelbrock 11002x2 Super intake
- Longdie-cast zinc SuperLink leverarms. All other partsstainless steel.
- Extended throttle shafts arenot required.
- Everykit comes with two newStromberg 'Snapback' throttlereturn springs, which wraparound the end of thethrottle shaft. Thesechemically blacked, stainlesssteel torsion springs snapthe carburettors shut, yetvirtually disappear fromview.
- For a smooth,lightweight look, the swivelsare positively fixed by asmall e-clip on the back, andthe small black set-screws onthe front have knurled endsfor a strong fix on thestainless rod.
Every Stromberg TwoSteplinkage kit comes with fullinstructions, and furtherhelp with selection,installation and tuning isavailable at our Tech Center.
CarburettorNOT Included In Picture